We are selling a Project Kit for this Water Level Controller which can be bought from our Online Store. The project kit is a modified version of the project shown above. This Water Level Controller project kit uses 4 float switches to measure water level. The status of water level in the tank and status of the motor is displayed using an LCD module. This system monitors the water level of the tank and automatically switches ON the motor whenever tank is empty. The motor is switched OFF when the overhead tank or container is FULL. Hello Abdul, you just cant replace 8051 with PIC or any other micro controller like AVR.
Fitur Printed Circuit Board (PCB). 1.7.2 Assembly Listing. Program-sumber assembly di atas. Instruksi-instruksi yang digunakan dalam memogram suatu program yang diisikan pada AT89S51 adalah. Laporan Running LED Circuit. Contoh Listing Program. Rangkaian Jam Digital Mikrokontroler. Doc speed control of a dc motor using micro controller 8051. The circuit is based on LM35 analog temperature sensor, ADC0804 and AT89S51 microcontroller. LM35 is an analogue temperature sensor IC which can measure a temperature range of -55 to 150°C. Its output voltage varies 10mV per °C change in temperature.
The reason is difference in “hardware architecture”. You can consider replacing the AT89S51 (from Atmel) microcontroller we have used in the circuit with other controllers of similar architecture – say AT89c52 or some other controllers. The controller must be compatible with MCS-51 instruction set too. If you are planning to use PIC, you can do so by rewiring the circuit in accordance with PIC architecture.
You will also have to rewrite the codes based on PIC instruction set.